WDS between Buffalo WHR-HP-G300N(DDWRT) and Engenius EOC2610/2611p(Stock firmware)

Equipments :

1x Buffalo WHR-HP-G300N flashed to DDWRT V-24 SP2, downloadable from buffalo website.

1x Engenius EOC-2610/2611p with stock firmware version 1.2.0.

The network is configured as below :

Modem--Wired--EOC2611p--Wireless--WHR-HP-G300N

• Modem local IP address is 10.254.0.1
• EOC-2611p IP address is 10.254.0.2
• WHR-HP-G300N IP address is 10.254.0.3
• The modem is configured as DHCP server, so all clients connected to EOC-2611p or WHR-HP-G300N will get DHCP IP from the modem.

EOC-2610/2611p configuration :

Please reset your device to factory default so that its easier for you to do the configuration !

System->System Properties -> Operation Mode : Access Point

System->IP Settings :

IP Address : 10.254.0.2

IP Subnet Mask : 255.255.255.0

Default Gateway : 0.0.0.0

Primary DNS : 0.0.0.0

Secondary DNS : 0.0.0.0

Wireless->Wireless Network

SSID : Hotspot

Security : Open System/No Encryption

Enable : Ticked

Profile SSID Isolation : No Isolation

WHR-HP-G300N configuration :

Please reset you devices to factory default so that its easier for you to do the configuration !

I believe image explain better, sorry for the blurry image.

After applying all the settings, login to your WHR-HP-G300N and check the status.

Now, take a laptop and try to connect to SSID "Hotspot 2" as per configured in your WHR-HP-G300N Wireless Virtual Interface. If you've done the configuration and setup a DHCP server(in your modem) correctly, the laptop should be getting a DHCP IP !

Hope this tutorial helps! Have a nice day!